CANVAC Q CLEAN R400 Instruction Manual download pdf (Page 52)

52  AUTO Mode

1 With the camcorder on and in a recording mode, close the LCD

panel.

A beep will sound and the green ON/OFF (CHG) indicator will change

to orange to indicate the camcorder entered standby mode.

2 When you wish to resume recording, open the LCD panel.

The ON/OFF (CHG) indicator turns back green and the camcorder is

ready to record.

IMPORTANT

• Do not disconnect the power source during standby mode (while the

ON/OFF (CHG) indicator is lit in orange).

NOTES

• The camcorder will not enter standby mode if the LCD panel is closed

while the ACCESS indicator is on or flashing or while the HOME menu

or menus contained therein (not including the [ Main Functions]

panel) are being displayed. The camcorder may also not enter standby

mode when the battery charge is too low. Check that the ON/OFF

(CHG) indicator changes to orange.

• About standby mode and auto power off:

- The camcorder will power off automatically if left in standby mode for

10 minutes. Press P to turn on the camcorder.

- You can select the length of time until shut-off or turn off the Quick

Start function altogether with the q> [Power Saving Mode] >

[Quick Start (Standby)] setting.

- The usual 5-minute auto power off setting of [Power Saving Mode] is

not applicable while the camcorder is in standby mode.

COPY

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 225 226

No comments

CANVAC Q CLEAN R400 Instruction Manual Page 52