CANVAC Q CLEAN R450 Operator's Manual download pdf (Page 101)

Page 99

Rev. 02 - 94753

Honey Bee Manufacturing Ltd.

2014 John Deere WS Swather

Operator’s Manual and Reference Guide

When adjusting the draper tension and tracking, check the clearance between the

draper deck slats and the end strut.

Draper tension should be just enough to prevent slipping. Do not overtighten as it

may cause failure to the bearings, draper rollers and/ or draper belts.

The draper may be damaged if it, or deck parts contact the end strut.

A minimum of 2" (50 mm) clearance is recommended. If necessary, loosen the deck restrainer and

slide deck over.

Tracking

The draper must track properly on the rollers to

avoid damage to the drapers. The draper decks

allow for approximately ¼” clearance on each side.

Idler Roller Tracking Adjustment

This roller is xed at the cutter bar, so is adjustable

only at the back panel. If the draper is tracking

toward the back panel, tighten the nut on the eye

bolt (shorten the eye bolt). This will push the idler

mount plate and idler roller at the back panel end

out, creating more slack in the draper at the cutter

bar.

If the draper tracks toward the cutter bar, lengthen

the eye bolt. This will pull the idler mount plate and

idler roller in, creating slack in the draper at the

back panel end.

The draper will track

to the slack side.

NOTE!

CAUTION

ATTENTION

Illustration A - Page 99 .

Caused by Improper

Draper Tracking

Illustration B - Page 99 .

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 169 170

No comments

CANVAC Q CLEAN R450 Operator's Manual Page 101