CANVAC Q CLEAN R450 Operator's Manual download pdf (Page 77)

Page 75

Rev. 02 - 94753

Honey Bee Manufacturing Ltd.

2014 John Deere WS Swather

Operator’s Manual and Reference Guide

NOTE!

JD R450 Install Pump Bracket And Set Pump Flow

Set the pump ow using high idle. Normal pump output is 45 GPM (170 LPM). The output from the

tractor must be set from 29 to 30 GPM (110 – 114 LPM). Install the ow bracket assembly onto the

motor mount, located under the windrower, as shown in Illustration “A”.

1. Remove the two nuts and bolts from the electric

swather pump output controller. Add the bracket as

shown in Illustration “A”, using the new 5/16” x 1”

bolts and nuts provided. Do not tighten yet.

2. Disconnect the linkage lever from the controller by unthreading the Ball & Socket from the

controller. Connect linkage lever by placing the threads of the ball through the hole on the

new bracket, and using the supplied M 6 nut fasten it securely. Use JD supplied ball stud.

3. Tighten the nuts and bolts from step 1 to secure the bracket in place.

4. Install a ow meter inline where the output hose is connected to the table.

5. Start the engine, engage table hydraulics, and set at high idle. Set the draper ow control to

full.

6. Adjust the bracket ne adjustment bolt until the ow meter shows 29 to 30 GPM (110 – 114

LPM). Secure the ne adjustment bolt with locking nut. Re check the ow meter to ensure it

has not changed.

The above procedure sets the correct amount of pump ow for the table. See

“Knife Drive Speed Adjustment” on page 120 for knife speed adjustment

details once the pump ow has been set.

Start at a low ow rate and increase in small increments. Setting ow above the 29

to 30 GPM stated above will result in excessive heating of oil and excessive draper

wear.

WARNING

Illustration B - Page 75

Pump Lever

Old HB

Bracket

Linkage

Illustration A - Page 75 .

To Pump

Lever

5/16” Bolts

Equipment

Linkage

Ball &

Socket

Bracket

Fine Adjustment Bolt

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 169 170

Comments to this Manuals

No comments

CANVAC Q CLEAN R450 Operator's Manual Page 77

Comments to this Manuals

Related products and manuals for Vacuum cleaners CANVAC Q CLEAN R450