CANVAC Q CLEAN R450 Operator's Manual download pdf (Page 41)

Page 39

Rev. 02 - 94753

Honey Bee Manufacturing Ltd.

2014 John Deere WS Swather

Operator’s Manual and Reference Guide

6. From port #1 of the valve assembly, install a 6MF–8MB 90º elbow to a ¼ “ 13” 6FFX–6FFX

hose, to a 6MB–6MF 90º elbow, which is then connected to the quick coupler levered valve

assembly.

7. On the tilt pressure hose, install a ¼”

female quick coupler and dust cap.

Install a 6MF–8MB nipple, and a

6MB-6FFX swivel adapter, to the valve

Assembly port #2.

8. From the valve assembly port #3,

connect a 6MF–8MB 90º elbow to

a 6MF–6FFX 90º swivel elbow, to a

6MB–6FFX swivel adapter, to a ¼

inch male quick coupler and dust plug.

This assembly will then be connected

to the 44 inch hose assembly.

9. From the Rod end of the cylinder,

install a 44” 6FFX–6FFX hose with a

6MB–6MF 90° elbow. On the other

end of the hose install a ¼ inch female

quick coupler with a 6MB–6MF nipple

plus dust plug.

10. On the return hose, install a ¼" male

quick coupler and dust cap. Install

a 6MB-6MF 45° elbow, and a 6MB-

6FFX swivel adapter, to the tilt cylinder

(piston end).

Refer to “Appendix A -

Hydraulic Fitting Naming

Standards” on page 141

for details on identifying

hydraulic ttings.

Refer to “A400 and R450 Hydraulic Tilt Cylinder Detail - Illustration A - page

37” for proper power unit quick coupler installation. A schematic can be found

on page 153.

11. Refer to Tilt Indicator – Detail illustration to the right. If not already applied, apply the indicator

decal to the aluminum tilt indicator, with “10” furthest away from the tilt cylinder rod end. Attach the

aluminum tilt indicator to the rod end using two snap rings and the cylinder bushing. Slide the tilt

indicator guide onto the tilt indicator and secure to the cylinder with two gear clamps. Ensure that the

tilt indicator guard is positioned rotationally on the cylinder so that the tilt indicator is parallel with the

tube of the cylinder. Any unnecessary tension on the tilt indicator and guide may cause damage to

those parts. With the cylinder retracted the tilt indicator guide should line up with “0” on the decal.

NOTE!

Illustration B - Page 39

Wiring Bracket Installed - Illustration A - Page 39 .

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 169 170

Comments to this Manuals

No comments

CANVAC Q CLEAN R450 Operator's Manual Page 41

Comments to this Manuals

Related products and manuals for Vacuum cleaners CANVAC Q CLEAN R450