CANVAC Q CLEAN R450 Operator's Manual download pdf (Page 107)

Page 105

Rev. 02 - 94753

Honey Bee Manufacturing Ltd.

2014 John Deere WS Swather

Operator’s Manual and Reference Guide

Installing Draper Motor

1. Clean motor shaft and hub of drive roller.

Apply anti-seize to shaft.

2. Insert key in motor shaft.

3. Insert motor into hub, lining key on shaft

with the key-way in the hub. Do not use a

hammer on housing ange; damage of this

nature to the motor will void warranty. Use a

soft blow or rubber hammer to apply force to

end of motor.

4. Tighten set screws.

Draper Deck Maintenance:

1. Remove draper connector bar.

2. Remove draper - clean draper of debris, both sides.

3. Store draper indoors.

4. Clean debris from rollers, deck channels, and runners.

5. Check and bend down corners of deck runners so draper does not get caught.

6. Clean adjusters; lubricate guide tubes and adjuster tubes. Adjusters should move freely

inside the guide tube.

7. Check idler roller bearings; they should spin freely.

8. Check drive roller bearings.

9. Check bearing stubs.

If you elect to store the swather outside with draper installed, position the

connector bar on the underside to aid water drainage. Ice build-up underneath

could cause draper to sag and drop out of the lower runner. If this is not noticed

and corrected, damage may occur to draper on start-up.

NOTE!

Drive Roller Motor Install -

Illustration A - Page 105 .

Key Way

Key

Motor Shaft

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 169 170

No comments

CANVAC Q CLEAN R450 Operator's Manual Page 107