CANVAC Q CLEAN R450 Operator's Manual download pdf (Page 132)

Page 130

Rev. 02 - 94753

Honey Bee Manufacturing Ltd.

2014 John Deere WS Swather

Operator’s Manual and Reference Guide

SCH Crop Lifters

Install the lifter spools to the underside of the guards

using the longer bolts supplied in the kit. The spools

should be spaced equally along the cutter bar, one

per foot is recommended.

The socket of the lifter has three locking pin

positions for adjusting the lifter angle. The lock pin

can be placed in any of the three holes. For

additional adjustment, at washers can be added

between the guard and the crop lifter spool.

For crop lifters to work properly the bottom runners

must be parallel to the ground when the platform is

in cutting position. Illustration “C”: Crop Lifter

Orientation shows the correct position of a standard

crop lifter.

The bottom runner of the Special Series lifter should

be parallel to the ground. To nd the correct

setting of the lifters for a given platform, drive on to

a smooth, at surface. Mount one lifter in the

middle of the platform.

Lower platform until crop lifter just touches the

ground. The runner of the lifter should be parallel

to the ground. If it is not, change lock pin positions

and if necessary, vary number of at washers until

the correct position is achieved.

Crop Liers Installed - Illustration A - Page 130 .

Crop Lifter Detail - Illustration B - Page 130 .

Crop Lifter Orientation - Illustration C - Page 130 .

Special Series Lifter - Illustration D - Page 130 .

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 169 170

No comments

CANVAC Q CLEAN R450 Operator's Manual Page 132