CANVAC Q CLEAN R450 Operator's Manual download pdf (Page 97)

Page 95

Rev. 02 - 94753

Honey Bee Manufacturing Ltd.

2014 John Deere WS Swather

Operator’s Manual and Reference Guide

Lubrication – Reel Shaft Bearings

Lubricate every 10 hours of operation (or daily) with

multi-purpose lithium base type grease. Lubricate

the grease tting at each end of the reel shaft, and

also at the center on double reel models.

Annually, remove and examine the polymer liners in

the control plate tubes. Replace if worn.

Initial lubrication of the plastic

bat bearings (HCC Reels only)

with a light lm of oil will

improve the break-in and

service life of the bearings.

Control Rings (U-II Reels only)

The control ring assemblies each have three rollers mounted in adjusting slots. To compensate for

wear to the control ring, the rollers may be adjusted outward in the slots so that all three rollers are

lightly in contact with the control ring.

All three rollers at each end of the reel must be moved the same amount

relative to each other, so that all three roller bolts are in the same position in

the slot. Do not move only one roller.

Check Points Before Operation:

Always engage reel lift cylinder locks and table lift cylinder locks before

working under or around raised reel. Do not rely on the power unit hydraulic

system for support. A rupture or a leak in any part of the system will cause

the table and reel to drop if the proper stops are not in place.

• All bolts are tight.

• Reel turns, by hand, without binding. (With some resistance from hydraulics.)

• Tines uniformly clear the knife.

• Reel arms are aligned. (No bow in the bat shaft or pivot bracket bat assemblies.)

• Auxiliary ngers have adequate clearance with side shields.

• Tine pitch has been set for the current application, and is uniform across swather.

• Hydraulic cylinders are functioning smoothly.

• Minimum reel height has been set correctly on the reel height control arms.

• Fore & aft hydraulic cylinders extend and retract fully.

• Vertical distance from the knife to the reel center is set for the current application.

• Reel is horizontally centered in the swather opening.

NOTE!

Illustration A - Page 95 .

Rollers (3)

Grease Fitting

Polymer Bushing

Behind Washer

WARNING

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 169 170

Comments to this Manuals

No comments

CANVAC Q CLEAN R450 Operator's Manual Page 97

Comments to this Manuals

Related products and manuals for Vacuum cleaners CANVAC Q CLEAN R450