CANVAC Q CLEAN R450 Operator's Manual download pdf (Page 98)

Page 96

Rev. 02 - 94753

Honey Bee Manufacturing Ltd.

2014 John Deere WS Swather

Operator’s Manual and Reference Guide

6 – Draper and Decks

Depending on the options purchased, there are two lateral drapers on the table which move the

crop to the opening. All drapers must be set, and maintained properly to perform well. Quick

release adjusters with spring tensioning allow easy access for cleaning, and maintain proper draper

tension. Unpack the draper. Check the size to ensure it is correct for the size of the deck.

Lower the swather to the ground or onto stable blocks, whichever provides the most

comfortable working height.

Raise the reel to its maximum height and place the locks on the reel lift cylinders to

prevent the reel from falling.

Lining Up the Idler Roller

Prior to installing the draper, ensure that the idler

roller (the draper roller without the motor) is

properly aligned. This is done by setting the end

of the offset plate ush with the c-channel of the

deck. Adjust the eye bolt until the end of the idler

plate contacts the stop on the offset plate if not so

already.

Once extended, you should make sure that

everything is parallel. The easiest way to do this, is

to measure the distance between the roller and the

closest cross brace on the draper deck. Make sure

measurement “A” is the same distance as

measurement “B”. If it still does not line up, you

may adjust the eye bolt again.

ATTENTION

Illustration A - Page 96 .

Offset Plate

Stop

Idler Plate

Illustration B - Page 96 .

Eye Bolt

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 169 170

No comments

CANVAC Q CLEAN R450 Operator's Manual Page 98