CANVAC Q CLEAN R450 Operator's Manual download pdf (Page 116)

Page 114

Rev. 02 - 94753

Honey Bee Manufacturing Ltd.

2014 John Deere WS Swather

Operator’s Manual and Reference Guide

Adjusting Table Float

Use the lightest oat setting, that will keep the table from bouncing, while allowing it to follow

uneven ground without gouging or scraping.

If the platform has been raised for any length of time, it may lower slowly or may

not lower all the way to the ground. This is due to the temperature difference in the

accumulator. Once the platform has been lowered and temperatures equalize, the

oat will function normally.

If the windrower does not maintain oat pressure, check the oat release valve on

the side of the high pressure valve, it must be closed. Refer to owner-operators

manual.

1. Park swather on level ground, lower platform and set engine speed at operating rpm.

Float pressure is displayed in increments of 10 psi.

2. For 4895 and 4995 tables (Illustration to the right):

a) Press platform oat function (B) on the digital tachometer.

b) For 4895 and 4995 tables, press and release ‘+’ on the oat witch

until platform starts to move upward.

c) Back off the psi reading, on the digital display (A), 100 psi by

pressing and releasing ‘-’ on the oat switch.

3. For A400 and R450 tables:

a) Press the platform oat function on the F-N-R Lever. You can nd

details on the A400 and R450 F-N-R lever in “In Cab Controls -

Illustration B - Page .” on page 55.

b) Slowly turn the rotary adjuster on the cab console clockwise until

the platform starts to move upward.

c) Back off the psi reading by slowly turning the rotary adjuster

counterclockwise.

4. Raise and lower the swather table several times.

5. With the swather table on the ground, stop the engine.

6. Check the platform oat by lifting at each end of the table. Normally it should require less than

150 lbs. (68kg) to lift the end of the table.

7. Adjust oat pressure as needed and repeat steps 5 through 7 until desired oat pressure is

attained.

Once the platform has been set, the system will retain the setting after the swather

has been stopped.

Refer to your owner’s manual for more information on the operation of the JD Self

Propelled Windrower.

NOTE!

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 169 170

No comments

CANVAC Q CLEAN R450 Operator's Manual Page 116