CANVAC Q CLEAN R450 Operator's Manual download pdf (Page 31)

Page 29

Rev. 02 - 94753

Honey Bee Manufacturing Ltd.

2014 John Deere WS Swather

Operator’s Manual and Reference Guide

Install Tilt Cylinder Quick Couplers

The John Deere tilt cylinder is not used with the Honey Bee swather. Honey Bee supplies a differ-

ent tilt cylinder for use with our equipment. Store the JD tilt cylinder in a clean, safe place.

Mark the hoses before removing them from the cylinder, so you can identify them

correctly for reassembly.

1. On the tilt pressure hose, install a 1/4” male quick coupler and dust cap. On 4895 and 4995

power units install a 4MF-6MB nipple (alternate tting 4MJ–6MB). For A400 and R450

power units, install a 4MF - 6MB nipple.

2. On the return side, install a 1/4” female quick coupler and dust plug. On 4895 and 4995

power units install a 4MF-6MB nipple (alternate tting 4MJ–6MB). For A400 and R450

power units, install a 4MF-6MB nipple.

3. Install a 6MB-6MF 90º elbow to the rod end of the cylinder, and from the elbow, a 6MB-6FFX

SW adapter then a 1/4" quick coupler and dust plug. Use a female coupler for the pressure

hose, and a male for the return hose connections.

The reel lift is controlled by the platform tilt circuit on the power unit. The hose

connected to the Front port of the tilt cylinder will be the reel lift pressure hose.

This hose from the power unit must have a male quick coupler and be connected

to the 'C2' port on the power unit manifold block. If the reel lift/tilt does not work,

check that the hoses are connected properly, and the couplers are fully engaged.

Tilt Cylinder Detail - Illustration A - Page 29 .

IMPORTANT

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 169 170

No comments

CANVAC Q CLEAN R450 Operator's Manual Page 31