CANVAC Q CLEAN R450 Operator's Manual download pdf (Page 62)

Page 60

Rev. 02 - 94753

Honey Bee Manufacturing Ltd.

2014 John Deere WS Swather

Operator’s Manual and Reference Guide

Install Strut Mounting Boots –

R450/4995 Specic Instructions

Swathers will have the mounting boots

preinstalled, however if installation is

required, follow these instructions.

1. Each mounting boot should be

installed ush against the edge closest

to the outside edge of the table on

each of the two center struts of the

swather as shown in the illustrations on

this page.

2. Each mounting boot should be held

against the outside wall of the strut

with the following parts:

a) Bolt – 1” x 12”

b) Spacer – 1½” x 3 5/16”

c) Spacer – 1½” x 5 ¾”

d) Nylock Nut – 1”

Some components are not shown in these illustrations for clarity reasons.

Illustration A - Page 60

Left Strut Mounting Boot

Illustration B - Page 60

Bottom of Center Struts

Left Right

Rear

Front

NOTE!

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 169 170

No comments

CANVAC Q CLEAN R450 Operator's Manual Page 62