CANVAC Q CLEAN R450 Operator's Manual download pdf (Page 89)

Page 87

Rev. 02 - 94753

Honey Bee Manufacturing Ltd.

2014 John Deere WS Swather

Operator’s Manual and Reference Guide

- Final Dismounting Steps.

20. With the oat pressure still set at minimum, carefully lower the swather so that the weight is

fully on the front wheel, hitch and rear axle.

Shut the engine down, set the parking brake, and wait for all moving parts to stop

before leaving the cab.

21. Remove the pins keeping the lock arms in the locked

position and reposition the lock arms on each of the

mounting boots to the dismount position as shown.

22. Restart the windrower and continue to lower the lift

arms while slowly backing away until the lift arms are

clear of the boots. For ease, additional lift arm

pressure can be relieved at this point by opening the

windrower's manual oat release valve.

If the swather moves, stop immediately and

nd the cause.

Once clear of the swather, engage the park

brake. Shut the engine down and wait for all

moving parts to stop before leaving the cab.

23. Attach the rear wheel and secure with the

hitch pin (Illustration “B”).

24. Lower the jack, remove it and re-install it in

the storage position (Illustration “C”).

25. Check that the swather is level. If necessary

adjust the height of the hitch jack.

26. Re-install the pins for the mounting boot lock

arms (Illustration “A”).

27. For A400 & R450 only: Re-install Pin 1 to

secure the cylinder mounting bracket in

place (Illustration “D”).

CAUTION

Illustration A - Page 87

Dismount

Position

Lock Arm

Illustration B - Page 87

CAUTION

IMPORTANT

Illustration C - Page 87

Jack in Storage

Position

Illustration D - Page 87

Pin 1

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 169 170

Comments to this Manuals

No comments

CANVAC Q CLEAN R450 Operator's Manual Page 89

Comments to this Manuals

Related products and manuals for Vacuum cleaners CANVAC Q CLEAN R450