CANVAC Q CLEAN R450 Operator's Manual download pdf (Page 86)

Page 84

Rev. 02 - 94753

Honey Bee Manufacturing Ltd.

2014 John Deere WS Swather

Operator’s Manual and Reference Guide

- Self Storing Hitch – Transport Position

6. To convert the hitch from storage to

transport mode, remove the safety chain

from the storage stub. Release the

pressure on the jack, loosen the hitch

clamp, and slide the jack off of the stub.

7. Pull the lock pin on hitch tube sleeve, and

then pull the hitch tube out of the hitch

tube sleeve. Reinsert the lock pin to

secure the tube.

8. Install the jack onto the Hitch Sleeve jack

mount tube, and tighten the hitch clamp

on the jack mount.

9. Extend the lower leg of the jack to a

suitable hole.

10. The swather should still be lifted from the

ground at this point with the table safety

lock in place.

- Install Transport Axle

11. Carefully lower the axle from the eld position to the

transport position. Ensure the hitch pin has been inserted

back into the strut in the transport position.

12. Remove the hitch pin securing the extension inside the

axle. Pull out the extension and relocate the pin to secure

for transport.

13. Install the wheel assembly onto the extension

on the cutterbar side of the table, insert lock pin

into spindle mount and secure with safety clip.

14. Install the transport axle jack to support the

weight at the rear of the table.

Illustration A - Page 84

Illustration B - Page 84

Illustration C - Page 84

Insert Pin

Install Jack

Illustration D - Page 84

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 169 170

No comments

CANVAC Q CLEAN R450 Operator's Manual Page 86